ITEC Cleaning Sink, type 20580 Clean and Dry
Cleaning and drying hands at a stainless-steel basin
With integrated hand drying technology from Dyson Airblade Tap, hands can be dried at the sink in just 12 seconds. A separate hand-drying area is unnecessary which prevents dripping onto floors and improves hygiene.
Water and air is supplied contactless – users do not need to touch the outlet. Intelligent infra-red sensors generate light to determine the precise positioning of hands. A highly effective HEPA filter removes
99.9 % of all air-borne bacteria and viruses before they reach the hands.
Contactless operation means water is consumed only when hands are held under the outlet. This reduces water consumption and operating costs.
Hygienic design with a stainless-steel rear panel and finely finished hygienic surfaces.
The integrated Dyson AIRBLADE™ Tap, a sensor fitting with an integrated hand dryer, enables hand cleaning and drying directly at the basin in just 12 seconds.
No extra hand-drying space required and no splashes onto floor surfaces.
Both water and air is controlled by a sensor, so no contact is necessary to outlet fittings or control buttons.
Water consumption is reduced significantly.
Cleaning troughs with two and three Dyson AIRBLADE™ Tap also available.
12-second drying time
A HEPA filter to remove 99.9 % of bacteria from the hand drying air
Low operating costs HACCP certified
Low CO2 emissions
No splashes on floor surf
Reduces water consumption via sensor-controlled water flow
For further information contact Henderson Food Machinery on 02890 994 202 or email firstname.lastname@example.org